Configuring Cisco PAP2T

How to get the IP Address:

  1. Plug in an analog phone into either phone1 or phone2 port.
  2. Press **** to enter the configuration menu.
  3. press 110# and listen to the voice announcing the ip address. (by default it’s set on DHCP)

How to configure the Phone ports to connect to Asterisk
1- Open a web browser and enter the IP address gained from above
2- The info screen will be shown

3- On the top right corner click on the “Admin Login” link to enter the admin page
4- The menus should be like this:


5- go to Phone1 and enter the extension information in the boxes provided

6- save settings and reboot the device
7- check the phone1 port by one analog phone to see if the config is correct

You may also like